ESP not showing in raid

ESP not showing in raid — 9 replies

1. D

   dma_box

   #1

   Classic first-launch thing. Overlay drawing but no boxes usually means Cloud DMA is not fully up. Did you enable HVCI, TPM, and Secure Boot in BIOS?

   ▲ 25 found this helpful

2. T

   tv_cqc OP

   #2

   Windows shows Core Isolation on. I have not actually gone into BIOS though.

   ▲ 14 found this helpful

3. D

   dma_box

   #3

   That is the trap — Windows can say on while firmware is off. Turn it on in BIOS itself, then reboot.

   ▲ 23 found this helpful

4. A

   abi_staff Staff Solution

   #4

   Empty ESP on a green status is almost always Cloud DMA requirements. Enable HVCI, TPM, and Secure Boot in BIOS, reboot, then launch in the order on the Setup page. Cloud DMA is required for the full feature set.

   ▲ 37 found this helpful

5. O

   obs_safe

   #5

   Also kill other overlays while you test — RTSS, GeForce, Discord. They can fight the stream-proof layer on first run.

   ▲ 8 found this helpful

6. T

   tv_cqc OP

   #6

   Secure Boot was off in BIOS even though Windows said on. Enabled it, rebooted, boxes are drawing now on Farm.

   ▲ 5 found this helpful

7. D

   dma_box

   #7

   Every time. Glad it was that and not a patch.

   ▲ 19 found this helpful

8. A

   ace_yellow

   #8

   For future — if ESP ever goes empty after a game update, check Updates first. Empty boxes on a yellow day is the build, not your setup.

   ▲ 26 found this helpful

9. A

   abi_staff Staff

   #9

   Right. If it is green and still empty after the BIOS steps, open a Support ticket with your order ID and we will walk it live.

   ▲ 29 found this helpful